Apply with a hopper gun, magic trowel (squeegee), steel pool trowel, brush, broom or roller For a knockdown texture use 8-15 PSI through a relatively large orifice. Add half the powdered material to the water, mix until lump free, let sit for 5 minutes, then blend in the other half. A brushed concrete finish is created by dragging a brush over the surface of a new concrete floor once it has been levelled to create a textured appearance. Mix in a clean 5 gallon pail with a ½”mixer drill (Do not use a cement mixer) Add EZChem EZ COLOR PAK (blend the Color Pak into the water first) if integral color is desired. Add 50 lb bag of Broomfinish Mix to approximately 5.5 quarts (minimum 4.5 maximum 6.5) of water. Remove any puddles and standing water (Saturated surface dry) prior to installation. Can be sealed with EZCHEM CLEAR ACRYLIC SEALER or COLORED ACRYLIC SEALER for a consistently colored and durable surface.īroomfinish Mix is typically applied to a damp surface.

The section on brooming in the Portland Cement Associations Cement.

Of course, that same quality also has an. For instance, one common specification for a trowel-and-fine-broom finish says to. Can be stained with EZCHEM ENVIRO STAIN or EARTHTONE STAIN for a wide array of decorative ﬁnishes. Adding a broom finish gives your concrete a slight, rough texture to help make walkways slip-resistant and safer.Can be integrally colored with EZCHEM EZ COLOR PAKS. In this video Im sharing with you my 5 best tips for getting that perfect broom finish on you concrete patios.In order to get a good broom finish on a concr.High bond, ﬂexural and compressive strength.It can be troweled or squeegee applied as a thin bond coat, or applied by hopper spray gun for a textured surface. BROOM FINISH MIX is a single component overlay system that bonds to all clean concrete surfaces to produce a rock hard, weather proof surface.

Broom finish concrete